Infusomat Space

1. Make sure the patient is safe — swap in a backup unit if you need to.
2. Reproduce the complaint yourself and write down exactly what you see (screen, alarm, code).
3. Check power, battery, cables, accessories, and settings before ordering parts.
4. Then open the service manual above and follow its troubleshooting section.

Device alarm source ↗

• Infusion stops: switch off and on
• If repeated, clamp, disconnect patient, remove set and send to service

'Pressure high' (occlusion) source ↗

• Check tubing for kinks/damage and IV/filter patency
• Raise occlusion pressure if appropriate

'Air bubble' / 'Accumulated air' source ↗

• Check set for small bubbles; disconnect and re-prime if needed

'Drive blocked' source ↗

• Excess pressure: disconnect patient and reinsert the line

Battery problems source ↗

• 'Battery empty': connect AC and/or swap pack
• 'Battery cover removed': push cover until it clicks
• 'No battery inserted': pump can't run without a pack
• Run monthly battery maintenance (~12 h); blinking battery >1 h on AC = have it checked

'Calibrate device' or wrench icon with yellow/red/blue LEDs source ↗

• Recalibrate via service program
• Wrench = service mode: not for patient use

'Communication error' pre-alarm source ↗

• Incompatible/defective device in the stack: have system checked

Occlusion source ↗

• Check for closed clamps/stopcocks, kinks, IV site patency
• Check pump height vs patient (LVP)

Air-in-line source ↗

• Look for small bubbles; disconnect and re-prime

Door/cassette/syringe loading source ↗

• Close door with set seated; check syringe clamp, flange and plunger holders

Battery/AC source ↗

• Run on AC; replace/maintain battery; battery service alarms → repair

Device/system error source ↗

• Power cycle once; if it repeats remove from service